As I stood looking at the engine in the frame a thought occurred.
Where are my feet going? I need to sort out some footrests BEFORE
I make the final engine plates. Looking at the images I have, the red line shows
the rough line the chain will take so the small X looks like a good
place to mount footrests...
...with appropriate guards fitted. From the rear this is what it should look like..
It's that or mount on the rear fork a little behind where the X is.
Whilst looking at the frame I noticed 2 holes just below the rear
fork at the base of the seat upright. A thought occured, so I slid a rod
into the hole and tried it for a potential footrest position.
And it might just work.